Motor Vibrator PT. SARANA TEKNIK Terlengkap

VIBRATOR QUANTUM TYPE VQC VIBRATOR QUANTUM TYPE VQB VIBRATOR QUANTUM TYPEI BMF n early electronics vibrators were used in inverter circuits to provide an alternating current (AC) electric power supply from a direct current (DC) source. The primary use for this type of circuit was for vacuum tube type automobile radios. Vacuum tubes require relatively high voltages ranging from about 45 volts to 450 volts in consumer electronics. For portable radios, hearing aids and similar equipment, B batteries were manufactured with various voltage ratings. In order to provide the necessary voltage for a radio from the typical 6 or 12 volt DC supply available in a car or from an isolated farm lighting battery, it was necessary to convert the DC supply to AC and use a transformer to increase the voltage. The rapid motion of the vibrator was used to operate a switch. The switch was used to alternate the connection of the 6/12 volt DC power between two terminals of a transformer, in effect, supplying an AC input voltage to the transformer. The transformer produced a higher voltage AC supply at its output terminals. This arrangement is a simple type of inverter circuit. The secondary AC voltage was then rectified by a vacuum tube or selenium rectifier. Sometimes the vibrator carried an extra set of contacts arranged for mechanical synchronous rectification. The vibrator switches used for this purpose were usually encased in a steel or aluminum can with a plug for mounting in a tube socket.